How to Install Laminate Wood Floors?

Let us get a step by step description as to how we go about installing laminate wood floors.

Step one
Calculation

Take measurements of the entire place which needs to be covered with the laminate wood floors. Moreover normally the length is taken alongside the longest wall and for a bigger area possibly the direction alongside where the traffic moves the maximum. The purchase of the flooring needs to be done with the square footage keeping the wastage component in mind.

Step two
Preparation of the area and the material

The entire area needs to be cleared and sorted out for the flooring. Moreover the boards which have been bought need to acclimatized before being used

Step three
Prepare the floor

Removal of all previous floorings or any padding on the floor needs to be done. The floor needs to be leveled out completely after which it would be vacuumed to remove all external dirt as well.

Step four
Trimming of door casing

All the bottoms of doors as well other areas need to be trimmed such that the flooring can slip easily under the door. An underlayment along with the flooring needs to be kept as a provision.

Step five
Rolling out the underlayment

Connect all the pieces with a clear and wide tape. Then roll out the underlayment on the floor being careful of leaving say a quarter inch clearance alongside the walls. Moreover, spacers need to be put along the walls as well which can be removed before we put the final baseboards.

Step six
Installation of the baseboards

Baseboards need to be cut and installed. Start installing the base boards from the corner and continue with placing it through the room. With the progress of every course the job gets a bit tricky. After placing all the boards, it needs to be stuck with glue while removing the excess glue from the sides.

It has to be done very carefully and not nailed into the planks. Each of them needs to be glued individually and with utmost care. A good way to avoid waste is to start with the planks which are remaining from the previous row as the first board in the next row.

Step seven

Finishing
The last course can be pressed and fitted properly with the help of a chisel or crow bar. Protection of the wall is necessary with a block or spacer. After the boards are stuck properly, the distancing blocks can be removed, and the trimmings from the corners, at the door casings etc can be done for the finishing touches.

Tips
• Acclimatization is very necessary, else the wooden floors will react to moisture and humidity depending on the seasons
• The glue which is user friendly but cannot be depended on completely. Proper ventilation needs to be given when the glue is wet since on drying up it becomes a tedious task to clean up the glue. The latter can also lead to damage of the floor

Similar Posts:

• 4 Tips on How to Install Wide Plank Laminate Wood Flooring
• How to Lay Laminate Flooring Correctly
• How to Install Laminate Flooring By Yourself
• Laminate Floor Installation: Step by Step
• How to Prepare Your Floors for Laminate